FAQs | Wet & Forget Ready-To-Use

Open the flip cap and firmly insert white hose tip until it snaps into place. Once attached, fully extend the hose to 3 ft [36 in]. After each use turn sprayer nozzle to 'OFF' position and snap back into bottle handle to avoid leaks. Once the trigger is connected store and transport in an upright position.

It depends on the type of growth and the intensity of the contamination. If it's a new growth or a small amount of staining you can see results within days. Otherwise, it may take 2-3 months to see improvement. In the very worst case scenario, where contamination is extreme, it may take 6-12 months to work. Green stains on fencing and walkways tend to clean-up quicker than black stains on roofs or concrete. You can re-apply another application 1 month after the first application to speed up the process.

Wet & Forget is best applied to a dry surface on a cool, windless day, when no rain is expected for 4-5 hours. Ideally, early morning is the best time to apply when the surface is cool, this will help avoid rapid evaporation of the product. Wet & Forget can be applied at any temperature above 32 degrees.

Wet & Forget Outdoor has an unlimited shelf life.

After application, keep your pets off the surface until it is dry to ensure they don't ingest any of the Wet & Forget Ready-To-Use. If they accidentally walk in the treated area while wet, rinse your pet's paws with fresh water as a precaution. Wet & Forget Ready-To-Use does not re-activate after the initial dry time so these precautions are only necessary during the first 4-5 hours after application.

Do not spray directly on plants. Do not apply on windy days to avoid spray drifting onto plants. You can protect plants from overspray by rinsing with water before and after application or covering them during application. Wet & Forget Ready-To-Use will not leach into the soil.

Yes, Wet & Forget Ready-To-Use is a multi-surface outdoor cleaner. It can be used on virtually any outdoor surface.

Wet & Forget Outdoor Ready-To-Use was developed to easily clean up smaller outdoor surfaces prone to algae, moss, mold and mildew. One bottle of the Ready-To-Use will cover approximately 60-180 square feet depending upon the porosity of the surface, the type of growth, and the severity of the stain.

Ideally, remove any excess debris. It's not necessary to wash the surface prior to application. Wet & Forget Outdoor must be applied to a dry surface.

We do not recommend storing Wet & Forget Outdoor in an area that could freeze or have temperatures below 32 degrees.

Yes, this is a normal and temporary color change that occurs on some concrete surfaces right after application. The color change indicates you've had a good reaction between the growth and Wet & Forget. The color will disappear over time. After a few days, you can hose the area to remove the orangey color quicker.

Yes, Wet & Forget Ready-To-Use is pre-mixed so no water is needed and there's no rinsing after application.

Wet & Forget Ready-To-Use is specifically developed for outdoor use and requires exposure to the weather. We do not recommend using Wet & Forget Ready-To-Use, indoors.
For indoor use, we recommend Wet & Forget Indoor Mold+Mildew Disinfectant Cleaner.